Instruction manual

Operation Instructions Rockhopper 3 Extreme
CHAPTER 3 : BASICS
20
AP-77150 – Rev. 2.0
Step 6 : Make the correct settings and press the [F4]-key to start the media initialization.
Step 7 : If everything is done correctly, the following screen should appear..
Notes
I
F THERE ARE ANY PROBLEMS DURING THE INITIAL START
-
UP OPERATION
,
THE PRINTER WILL DISPLAY A MESSAGE ON
THE OPERATION PANEL
, AND THE OPERATION MAY STOP. IF THE OPERATION STOPS,
REFER TO
"T
ROUBLESHOOTING
",
AND TAKE THE APPROPRIATE ACTIONS
.
Step 8 : Before start printing, be sure to perform a nozzle check to ensure all nozzles are present. If not,
perform the necessary cleaning cycles.
3.2 POWERING OFF CYCLE
Power OFF the printer according to the procedure below:
Notes
P
LEASE BE SURE TO PERFORM THE NECESSARY MAINTENANCE BEFORE POWERING
OFF
THE MACHINE
.
A
LL DETAILS
CAN BE FOUND IN CHAPTER 4.
Step 1 : Verify the following regarding the operational condition of the printer:
Ø There is no printing operation being performed.
Ø The operation panel is in the main screen.
Step 2 : Press the [POWER] key of the operation panel to switch OFF the printer.
Step 3 : [Power OFF] will be displayed for a few seconds
Ø Following message is displayed on the operation panel.
Ø All lamps and the LCD of the operation panel will switch OFF.
Ø The printer will automatically perform a TubingFlush and power OFF.