Instruction manual

Operation Instructions Rockhopper 3 Extreme
CHAPTER 3 : BASICS
19
AP-77150 – Rev. 2.0
3 BASICS
3.1 POWERING ON CYCLE
Caution
B
EFORE POWERING
ON
THE PRINTER
,
MAKE SURE THAT THE WASTE BOTTLE IS INSTALLED AND THAT THE WASTE
TUBES ARE CONNECTED TO THE WASTE BOTTLE.
Power ON the printer according to the procedure below:
Step 1 : Press the [POWER] key of the operation panel.
The POWER lamp of the operation panel will light (green).
Step 2 : The printer will ask if you want to clean the wipers. When it is the first start up in a few hours, it is
highly recommended to press [YES] – [F2] and to clean the wipers with Mutoh Eco-Solvent Ultra
cleaning in order to remove all ink and to make the wipers more elastic.
Step 3 : Press the ENTER key when you have done. The carriage will cap in again.
Step 4 : After finishing the daily maintenance, the print will automatically perform a normal cleaning.
Step 5 : After finishing the cleaning cycle, the media measurement screen will be displayed (in case there
is media loaded)