Specifications

4 Part Replacement PJ-1614NXE PJ-2216NXE Maintenance Manual
4-50
3. Disconnect the tubes from the sub tank assembly.
4. Remove two screws retaining the sub tank assembly.
5. Replace the sub tank assembly.
6. To install the removed components, reverse the removal procedure.
NOTE
When replacing the sub tank, do not lose the polyacetal spacers.
(3) Replacing cartridge heater and thermister
1. Remove the sub tank assembly following the instructions in "(2) Replacing sub tank assembly".
2. Disconnect the cartridge heater and thermister connectors from the CR_BASE board assembly.
3. Remove the cartridge heater and thermister from the sub tank assembly.
No. Part name
1 Valve bracket
2 Valve bracket-retaining screw (M3×12)
3 Sub tank assembly-retaining screw (M3×8)
4 Sub tank assembly
1
4
3
2
2
1
3
2