Specifications

PJ-1614NXE PJ-2216NXE Maintenance Manual 4 Part Replacement
4-47
4.6.4 Replacing P_EDGE Sensor Assembly
NOTE
Before replacing the P_EDGE sensor assembly, remove the following covers.
• Side cover R: "4.2.1 Removing Side Cover R"
• Side cover L: "4.2.2 Removing Side Cover L"
• Front cover: "4.2.3 Removing Front Cover"
• Y-axis rail cover: "4.2.5 Removing Y-axis rail cover"
• Carriage cover: "4.2.8 Removing Head Cover"
1. Disconnect the P_EDGE sensor assembly connector from the CR_BASE board assembly.
2. Remove the one screw retaining the P_EDGE sensor assembly.
3. Replace the P_EDGE sensor assembly.
4. To install the removed components, reverse the removal procedure.
No. Part name
1 P_EDGE sensor assembly
2 P_EDGE sensor assembly-retaining screw (M2×6)