Specifications

PJ-1614NXE PJ-2216NXE Maintenance Manual 4 Part Replacement
4-45
NOTE
Before replacing the head assembly, remove the following covers.
• Side cover R: "4.2.1 Removing Side Cover R"
• Side cover L: "4.2.2 Removing Side Cover L"
• Front cover: "4.2.3 Removing Front Cover"
• Y-axis rail cover: "4.2.5 Removing Y-axis rail cover"
• Carriage cover: "4.2.8 Removing Head Cover"
1. Perform ink purge to discharge ink from all ink lines.
TIP
"5.5.10 Head Cleaning Menu"
2. Move the carriage leftward from the capping position.
3. Remove the HEAD board assembly following the instructions in "4.6.1 Replacing HEAD Board
Assembly".
4. Remove the two tubes
5. Remove the three screws retaining the head assembly.
6. Remove the head assembly by pushing it rearward.
7. Replace the head assembly.
8. To install the removed components, reverse the removal procedure.
9. Perform adjustment following the instructions in "3.2 Product Specifications".
No. Part name
1Tube
2 Head assembly
3 Head assembly-retaining screw (M3×6)