Specifications

PJ-1614NXE PJ-2216NXE Maintenance Manual 4 Part Replacement

4-39

3. To install the removed components, reverse the removal procedure.

NOTE

• The driven pulley shaft fits only in one orientation. Ensure that it is oriented correctly referring to "10.6 Exploded

View"

• After installing the CR driven pulley, always ensure that the steel belt is evenly guided along the CR motor assembly

pulley by moving the carriage left and right by hand.

4. Perform adjustment following the instructions in "3.2 Product Specifications".

4.5.7 Replacing Steel Bearer, Tube Guide, CR Tape Wire, and Intake

Tube

NOTE

Before replacing the steel bearer and tube guide, remove the following covers.

• Side cover R: "4.2.1 Removing Side Cover R"

• Side cover L: "4.2.2 Removing Side Cover L"

• Front cover: "4.2.3 Removing Front Cover"

• Y-axis rail cover: "4.2.5 Removing Y-axis rail cover"

1. Remove the six screws retaining the wire holder.

No. Part name

1 CR driven pulley

2 Steel belt

No. Part name

1 Wire holder

2 Screw retaining wire holder (M3×8)