Specifications

PJ-1614NXE PJ-2216NXE Maintenance Manual 4 Part Replacement

4-35

NOTE

• When installing the CR motor assembly, ensure that the steel belt is evenly guided along the CR motor assembly

pulley by moving the carriage left and right by hand.

14. To install the removed components, reverse the removal procedure.

4.5.3 Replacing SLID Motor Assembly

NOTE

Before replacing parts of the SLID motor assembly, remove the following covers.

• Side cover R: "4.2.1 Removing Side Cover R"

• Side cover L: "4.2.2 Removing Side Cover L"

• Front cover: "4.2.3 Removing Front Cover"

• Y-axis rail cover: "4.2.5 Removing Y-axis rail cover"

1. Disconnect the SLID motor assembly connector from the MAIN board.

2. Remove the two screws retaining the SLID motor assembly.

3. Replace the SLID motor assembly.

4. To install the removed components, reverse the removal procedure.

No. Part name

1 SLID motor assembly

2 Screw retaining SLID motor assembly (M3×6)