Specifications

PJ-1614NXE PJ-2216NXE Maintenance Manual 4 Part Replacement

4-25

3. Remove the paper sensor bracket.

4. Remove the two screws retaining the P_REAR_R sensor assembly.

5. Replace the P_REAR_R sensor assembly.

6. To install the removed components, reverse the removal procedure.

4.4.4 Replacing Lever Motor Assembly

NOTE

Before replacing the lever motor, remove the following covers.

• Side cover R: "4.2.1 Removing Side Cover R"

• Side cover L: "4.2.2 Removing Side Cover L"

• Front cover: "4.2.3 Removing Front Cover"

• Y-axis rail cover: "4.2.5 Removing Y-axis rail cover"

• Paper guide R: "4.2.7 Removing Paper Guide R"

1. Disconnect the lever motor assembly connector.

2. Remove the one screw retaining the sensor bracket.

No. Part name

1 Paper sensor bracket

2 Paper sensor bracket-retaining screw (M3×8)

No. Part name

1 P_REAR_R sensor assembly

2 P_REAR_R sensor assembly -retaining screw (M2×5)