Specifications

PJ-1614NXE PJ-2216NXE Maintenance Manual 9 Troubleshooting
9-7
3 Roll paper end This error is
issued when
paper end is
detected in roll
paper mode.
Lifting lever
upward cancels
this error.
(1) Turn machine OFF. Turn
it ON again and check if the
same message appears.
If message
appears: Step (2)
Å\
(2) Check contact of
P_REAR sensor assembly.
ÅEReconnect MAIN board
assembly connector J117. If
machine does not initialize
paper, sensor may be
damaged. Replace P_REAR
sensor assembly.
4.4.3
Replacing
P_REAR_R
sensor assembly
(3) MAIN board assembly
may be damaged.
ÅEReplace MAIN board
assembly.
4.3.2
Replacing MAIN
Board Assembly,
DIMM,
MOTHER Board
Assembly,
HDD_MOTHER
Board Assembly
4 [ ] Little ink Ink is running
short. Printout is
possible.
(1) Check for ink end from
"Sensor: etc." of self-
diagnosis function.
ÅECheck if ink end display
from "Sensor: etc." changes
when moving level switch
up and down.
5.4.4 Sensor
Menu
5 [ ] No ink Ink has run out.
Any printout
operation stops
immediately.
(1) Check level switch
connector for contact.
ÅEReconnect following
connectors.
ÅEJ2(K)
ÅEJ3(Y)
ÅEJ4(Lm)
ÅEJ5(M)
ÅEJ6(Lc)
ÅEJ7(C)
ÅEJ10(JW)
ÅEJ11(waste fluid)
4.9.1
Replacing
TERM_TANK
Board Assembly
6 Warning: Waste
fluid tank
Waste fluid tank
is almost full.
(1) Turn machine OFF. Turn
it ON again and check if the
same message appears.
ÅEIf message
appears: Step (2)
Å\
(2) Waste ink in waste fluid
tank reaches full level.
ÅEDispose of waste fluid in
waste fluid tank.
Å\
(3) TERM_TANK board
assembly may be damaged.
ÅEReplace TERM_TANK
board assembly.
4.9.1
Replacing
TERM_TANK
Board Assembly
Table 9-3 Symptoms and Check Items for Errors with Message (Continued)
No. Message
Event/
symptom
Check item Action Reference