Specifications

9 Troubleshooting PJ-1614NXE PJ-2216NXE Maintenance Manual
9-6
Table 9-3 Symptoms and Check Items for Errors with Message
No. Message
Event/
symptom
Check item Action Reference
1 Paper detection
error
Paper detection
failed
(1) Is P_EDGE sensor
assembly at cursor
connected correctly?
ÅESecurely connect it to
CR_BASE board assembly
connector J004.
4.7.2
Replacing
CR_BASE
Board Assembly
and CR_HEAD
Board Assembly
(2) Is P_REAR sensor
assembly under paper guide
R connected correctly?
ÅESecurely connect it to
MAIN board assembly
connector J117.
4.3.2
Replacing MAIN
Board Assembly,
DIMM,
MOTHER Board
Assembly,
HDD_MOTHER
Board Assembly
(3) Is CR tape wire inserted
obliquely?
Reconnect following
connectors.
ÅESUB board assembly:
J006 - J007
ÅECR_BASE board
assembly: J1 - J2
ÅECR_HEAD board
assembly
4.3.2
Replacing MAIN
Board Assembly,
DIMM,
MOTHER Board
Assembly,
HDD_MOTHER
Board Assembly
(4) CR tape wire may be
broken.
ÅEReplace CR tape wire.
4.5.7
Replacing Steel
Bearer, Tube
Guide, CR Tape
Wire, and Intake
Tube
(5) CR_HEAD board
assembly and CR_BASE
board assembly may be
damaged.
ÅEReplace CR_HEAD
board assembly and
CR_BASE board assembly.
4.7.2
Replacing
CR_BASE
Board Assembly
and CR_HEAD
Board Assembly
(6) Check if P_REAR
sensor is ON from "Sensor:
etc." of self-diagnosis
function.
ÅEIf this message appears
though paper is set, replace
P_REAR sensor assembly.
4.4.3
Replacing
P_REAR_R
sensor assembly
(7) MAIN board assembly
may be damaged.
ÅEReplace MAIN board
assembly.
4.3.2
Replacing MAIN
Board Assembly,
DIMM,
MOTHER Board
Assembly,
HDD_MOTHER
Board Assembly
2 Paper skew error Paper is running
obliquely.
(1) Set paper again and
check repeatability.
ÅEIf this error is caused by
user's inappropriate paper
setting, instruct correct
paper setting procedure.
Å\