Specifications

9 Troubleshooting PJ-1614NXE PJ-2216NXE Maintenance Manual
9-4
3 No paper No paper is set. (1) Is P_EDGE sensor
assembly at cursor
connected correctly?
ÅESecurely connect it to
CR_BASE board assembly
connector J004.
4.7.2
Replacing
CR_BASE
Board Assembly
and CR_HEAD
Board Assembly
(2) Is P_REAR sensor
assembly under paper guide
R connected correctly?
ÅESecurely connect it to
MAIN board assembly
connector J117.
4.3.2
Replacing MAIN
Board Assembly,
DIMM,
MOTHER Board
Assembly,
HDD_MOTHER
Board Assembly
(3) CR_HEAD board
assembly and CR_BASE
board assembly may be
damaged.
ÅEReplace CR_HEAD
board assembly and
CR_BASE board assembly.
4.7.2
Replacing
CR_BASE
Board Assembly
and CR_HEAD
Board Assembly
(4) Check if sensor is ON
from "Sensor: etc." of self-
diagnosis function.
ÅEIf this message appears
though paper is set, replace
P_REAR sensor assembly.
4.4.3
Replacing
P_REAR_R
sensor assembly
(5) CR tape wire may be
broken.
ÅEReplace CR tape wire
assembly.
4.5.7
Replacing Steel
Bearer, Tube
Guide, CR Tape
Wire, and Intake
Tube
(6) MAIN board assembly
may be damaged.
ÅEReplace MAIN board
assembly.
4.3.2
Replacing MAIN
Board Assembly,
DIMM,
MOTHER Board
Assembly,
HDD_MOTHER
Board Assembly
Table 9-2 Events and Check Items for Operation Status Messages (Continued)
No. Message
Event/
symptom
Check item Action Reference