Specifications
7 Adjustment PJ-1614NXE PJ-2216NXE Maintenance Manual
7-6
7.3.2 Downloading Backup Parameters
This section describes the procedure to download the backup parameters to the memory card from the
existing main board assembly.
Follow the steps below.
1. Remove the memory cover.
2. Prepare a memory card for parameter backup and insert it in the memory card connector slot (J108)
of the MAIN board assembly.
NOTE
The memory card front face should direct to the inside of the machine.
3. Press the Power key in the operation panel.
• After all lamps in the operation panel light up for an instant, the LCD displays
"PLOTTERŮCARD".
4. Press the Confirm key in the operation panel.
• The LCD displays "PÅ®C Started".
• The backup parameter download starts.
5. Verify that the backup parameters are downloaded correctly and "PŮC Completed" appears on the
LCD.
6. Turn the machine power OFF.
7. Remove the memory card.
7.3.3 Installing Backup Parameters
This section describes the procedure to install the backup parameters in the memory card to a new MAIN
board assembly. Follow the steps below.
1. Insert the memory card with backup parameters in the memory card connector slot of the new MAIN
board assembly.
NOTE
The memory card front face should direct to the inside of the machine.
2. Press the Power key in the operation panel.
• After all lamps in the operation panel light up for an instant, the LCD displays
"PLOTTERŮCARD".
3. Press the Set value key or the Set value key to change the display to "CARDŮPLOTTER".