Specifications

5 Self-Diagnosis Function PJ-1614NXE PJ-2216NXE Maintenance Manual
5-26
NOTE
For an 87-inch spec, the items "Head 1-5" and "Head 1-6" are also available.
5.5.7 Band Feed Correction Menu
In this menu, you can correct the paper feed distance.
To correct the paper feed distance, you must first print out check patterns and measure the distance
between lines drawn in the paper feed direction. Then you enter the measured value through this menu.
The system uses this entered value to determine the PF encoder resolution parameter in the firmware.
The actual procedure is as follows.
1. Set paper as necessary.
2. After paper is set, the machine prints out band feed correction patterns in the following modes.
• Length: 300 - 1000mm
• 2 pass Single way
• PF: 180dpi, CR: 180dpi
3. Check the printed band feed correction patterns for the following point.
• Paper feed amount