Specifications

5 Self-Diagnosis Function PJ-1614NXE PJ-2216NXE Maintenance Manual
5-10
5.4.4 Sensor Menu
This menu displays the sensor status in the operation panel.
If the displayed sensor status does not match the actual machine status, replace or adjust the relevant
sensor referring to "Table 5-3 Inspection Items in Sensor Menu".
NOTE
• The sensitivity of the following sensors is displayed by a hexadecimal number.
• P_EDGE sensor
• Vacuum sensor
• For the ink end sensor, the color of the ink that has run out is displayed.
• For an 87-inch model, the items for head temperature, sub tank temperature, valves, and ink level (High/Low)
also include the data of the No.5 and No.6 heads. The items for platen temperature and dry temperature also
include the data of the No.4 head.
Table 5-3 Inspection Items in Sensor Menu
No. Sensor name Status in display Reference
1 Head thermister **°C
4.6.1 Replacing HEAD Board Assembly
2 Sub tank **°C
3 Platen **°C
4 Thermister (dry) **°C
5 Valve sensor Sensor error / Jet wash /
Ink side / Sensor error
6 Ink level sensor Enough / Poor
7 Cable sensor OK / NG
8 Paper feed/wind sensor ON / OFF
9 CR_HP sensor ON / OFF
4.5.2 Replacing CR Motor Assembly
10 HD_SLIDE sensor ON / OFF
4.5.3 Replacing SLID Motor Assembly
11 Cover sensor Open / Close
7.8 Cover Sensor Adjustment
12 Cover maintenance sensor Open / Close
13 Lever sensor Up / Down
4.5.4 Replacing HD_SLIDE Sensor
Assembly
14 Foot lever sensor ON / OFF
15 Waste fluid sensor OK / Full
16 Vacuum sensor 0 to FF
17 P_EDGE sensor 0 to FF
7.9.1 Jigs and Tools
18 P_REAR sensor ON / OFF
7.9.2 Adjustment Procedure
19 Ink END sensor KCMY (64-inch spec)
KCMmY (87-inch
spec)
4.8.1 Replacing Ink Pump