Specifications

4 Part Replacement PJ-1614NXE PJ-2216NXE Maintenance Manual
4-76
4. Disconnect the connectors from the TERM_ROLL board assembly.
5. Remove the one screw retaining the roller shaft.
6. Remove the three screws retaining the winding unit.
7. Remove the winding unit.
8. Disconnect the connector from the winding unit switch assembly.
9. Remove the two screws retaining the winding unit switch assembly.
10. Replace the winding unit switch assembly.
NOTE
When removing the winding unit switch assembly, exercise extreme caution not to drop the switch nut on to the
TERM_ROLL board assembly.
11. Replace the two snaps located left and right that retain the limiter shaft.
12. Replace the mini keeper.
No. Part name
1 Winding chassis
2 Hexagon socket bolt
3 Roller shaft-retaining screw (M3×8)
4 Winding unit-retaining screw (M4×8)
5Clamp
6Roller shaft
7 Winding unit
No. Part name
1 Winding unit switch assembly-retaining screw (M3×16)
2 Winding unit switch assembly
3 Switch nut
1
3
2