Specifications

PJ-1614NXE PJ-2216NXE Maintenance Manual 4 Part Replacement
4-75
3. Remove the six screws retaining the winding unit cover.
4. Disconnect the connectors from the TERM_ROLL board assembly.
5. Remove the four screws retaining the TERM_ROLL board assembly.
6. Replace the TERM_ROLL board assembly.
7. To install the removed components, reverse the removal procedure.
4.10.2Replacing Winding Unit Components
(1) 64-inch model
1. Remove the TERM_ROLL board assembly following the instructions in "4.10.1 Replacing
TERM_ROLL Board Assembly".
2. Remove the two screws retaining the winding unit sensor base.
3. Remove the four winding chassis-retaining bolts. Remove the cable from the clamp located at the
back.
No. Part name
1 Winding unit cover-retaining screw (M4×8)
2 Winding unit cover
3 TERM_ROLL board assembly-retaining screw (M3×6)
4 TERM_ROLL board assembly
1
2
3
4
6
7
5
4
3
2
3
5
1