Specifications

4 Part Replacement PJ-1614NXE PJ-2216NXE Maintenance Manual
4-56
4.7.4 Replacing Three-way Valve
1. Remove the CR_BASE board assembly following the instructions in "4.7.2Replacing CR_BASE
Board Assembly and CR_HEAD Board Assembly".
2. Remove the four screws retaining the filter bracket.
3. Slide the filter bracket backward.
4. Disconnect the tubes from the three-way valve.
5. Remove the sub tank assembly located in front of the three-way valve to be replaced following the
instructions in "4.7.1Replacing Sub Tank Assembly".
If your machine is an 87-inch model, you must also remove the sub tank assemblies at the both
ends.
6. Remove the four screws retaining the CR board bracket.
7. Lift the CR board bracket.
8. Remove the two screws retaining the three-way valve.
No. Part name
1 Filter bracket
2 Filter bracket-retaining screw (M3×8)
No. Part name
1 Three-way valve
1
2
1
2