User`s guide

Operations Instruction Osprey 75/102/130
9 AP-75720, Rev. 2.0 - 28/11/2007
If there is contact in eyes or inhalation, it may cause poisoning. Follow the cautions and procedures
labelled on the ink and jet wash bottles, and take action immediately.
¾ The waste fluid from the printer is a waste oil (waste ink) of industrial waste. Proper waste fluid disposal
according to industrial waste disposal laws and ordinances of your local governments are required.
¾ Follow the instructions below when handling the power cable.
• Do not modify the cable
• Do not put heavy objects on the cable
• Do not bend, twist, or pull the cord
• Do not wire the cable near equipment that generates heat
¾ Follow the instructions below when handling the power plug. Otherwise, fire may occur.
• Wipe away dust and any other residue before inserting the plug.
• Ensure that the plug is firmly inserted as far as it will go.
¾ When handling the foot switch, be wary of the following:
• Do not place anything heavy on the foot switch
• Do not bend the cable of the foot switch with force, and do not pull.
Do not place the foot switch near thermal devices.
¾
When opening/closing the front cover and the maintenance cover, be careful not to get fingers caught in
the lid.
¾
The refilled ink or jet wash fluid must not exceed the upper limit (about 2 litres) of the main tank. If it
exceeds the upper limit, the ink will leak out and cause printer problems.
¾
When filling the main tank with ink, make sure not to make a mistake with the ink colour and the ink tube
colours.
¾
Filling the tank with wrong colour ink can make the print head useless.
¾
During printing, do not touch the media guide. The media guide is hot, and may cause burns if touched.
¾
During the winding operation, make sure to keep hands and fingers clear of moving parts.
¾ When cutting the roll media, be careful of the following. Incorrect handling can result in injury to the hands
and fingers from the razor blade.
• When holding the media, do not place fingers over the media cut groove.
• Move the razor blade slowly along the media cut groove.
¾ Do not use the jet-wash fluid, thinner, Benzene, alcohol, or other active agents except for the following
parts.
Doing so may result a malfunction in the product.
• Inside the maintenance cover
• Print head surface
¾ Be careful not to spill water inside the printer. Doing so may result in a short circuit.
¾ Never open the covers fixed with screws. Doing so may result in electrical shock or a malfunction in the
printer.
¾ When cleaning the print head, be careful of the following. Incorrect cleaning may result in clogging of the
nozzles.
• Do not touch the print head surface with bare hands.
• Wipe out ink on the print head wiper every time when ink is adhered to it.
Downloaded From ManualsPrinter.com Manuals