User`s guide
Operations Instruction Osprey 75/102/130
65 AP-75720, Rev. 2.0 - 28/11/2007
5.1.5 Criteria for the media feed
The criteria for the media feed that can be used for this product are as follows.
Before using media, confirm the following evaluation items.
Notes
• Among the following items, if following problems occurred, may not be warranted even if the
Maintenance contract has been concluded. (Repair may require expense.)
• No.1 to 3, 6 to 8, 13, 14
Notes
• Please refer to: "Menu setup on the operation panel" for details of the setup menu.
No. Evaluation Item Evaluation Method Criteria
1
Paper float, cockle,
friction
1. Set "High" for the print head height
menu of the operation panel.
2. Confirm the following operation.
• Perform no printing, media
feed only.
• Perform 4m printing by 200%
print.
• No Paper float, cockle, friction
• Or media should not make friction
with the print head nozzle.
2 Anti static
1. Set following items for the Printing
mode menu of the operation panel.
• Printing quality:360dpi×180dpi
• Printing direction: Bi-direction
2. Perform a printing of one-roll
(min.20m).
No error printing, error feed, and
machine-stop.
3 Slant
1. Set following items for the Printing
mode menu on the operation
panel.
• Printing quality:360dpi×360dpi
• Printing direction: Uni-direction
2. Perform printing.
Within 30m±0.1% with left/right edge of
the media as the baseline
4
Detect the end of
roll media.
After Media setting, confirm the end of
roll media.
No error for detection of the end of roll
media.
5 Media sensor After Media setting, detect media. No error for media detection sensor.
6
Weight, Diameter,
Number of
rolling
Confirm media visually.
• Max. 2600 mm
• External diameter: Max. 250 mm
• Weight: Max. 140kg
7 Thickness Confirm media visually. Within 0.08 mm-1.0 mm
8
Rolling start of
cardboard
core
Confirm media visually.
• Media breakaway without
cardboard
• core lift
• No remains of adhesives on
media.
9
Condition of both
edges of
roll media
Confirm media visually.
10 Roll direction Confirm media visually.
Align the edges equally.
Tolerance: +2.0 mm, -1.5 mm
• The printable side is outside.
• Printable side with inside will not
be guaranteed.
Downloaded From ManualsPrinter.com Manuals