User`s guide

Operations Instruction Osprey 75/102/130
41 AP-75720, Rev. 2.0 - 28/11/2007
Step 2 : Pull out the roll media from the feed slot, and fix into place with tape so that the leading edge is
parallel with the media tube.
No. Name
1 Roll media
2 Media tube
3 Cushioning roller
Notes
• When setting the roll media to the winding unit,
• Check the front and back of the product and make sure the media is free of wrinkles or slack.
• Install the media on the media tube so that the printing side faces outside. The media cannot be wound
if the printable side faces inside.
• Cutting the both sides of the media allows you to wind well the roll media as shown in the next figure.
a. Front section
Downloaded From ManualsPrinter.com Manuals