User`s guide

Operations Instruction Osprey 75/102/130
29 AP-75720, Rev. 2.0 - 28/11/2007
3.1.2 Switching the power OFF
Power OFF the unit according to the following procedure:
Step 1 : Follow “Testprinting”, and perform nozzle check printing.
Step 2 : Verify if there is any clogging of nozzles, missing dots, or faint printing.
Notes
• If printing, quality declines, or if missing dots are evident after the nozzle check, the print heads need to
be cleaned.
• Refer to: “Head cleaning" to perform head cleaning.
• If switching the power OFF without head cleaning, the clogged nozzle may not restore.
Step 3 : Verify the following regarding the operational condition of the product.
• There is no printing operation being performed.
• The control panel is in a normal status.
Step 4 : Push the [POWER] key of the control panel, to switch the unit OFF.
Notes
• The power is ON if the control panel displays the following conditions:
• The [POWER] key is in the pushed in condition
• The POWER lamp is lit (green).
• Press the [POWER] key again to switch the power OFF.
Step 5 : Following message is displayed on the operation panel for 3 seconds.
Notes
• If pushing the [POWER] key on the operation panel by mistake, push [POWER] key again while the
following message is displayed.
Step 6 : The product will perform the power OFF operation.
• The following message is displayed on the operation panel.
Step 7 : Open the maintenance cover.
Step 8 : Put the purge plate down.
Downloaded From ManualsPrinter.com Manuals