User`s guide

Operations Instruction Osprey 75/102/130
27 AP-75720, Rev. 2.0 - 28/11/2007
3 BASICS
3.1 SWITCHING THE POWER ON/OFF
3.1.1 Switching the power ON
Step 1 : Open the maintenance cover.
Step 2 : Holding the front of print head cap put the purge plate down.
No. Name
1 Print head cap
2 purge plate
Step 3 : Tilt the print head cap to eliminate the pooled liquid including jet-wash fluid.
Step 4 : Remove the print head cap.
Step 5 : Rise to set the purge plate.
Notes
• The purge plate must be placed on the purge stand whenever the power is ON, except in the case
when head cleaning is performed.
• When performing head cleaning (Refer to: “Head cleaning”)
• If waste fluid comes into contact with the inside of the product, the product may malfunction.
Step 6 : Close the maintenance cover.
• Close firmly until the covers are fixed into place.
Step 7 : Press the [POWER] key of the control panel, to switch the unit ON
• The POWER lamp of the control panel will light (green).
Downloaded From ManualsPrinter.com Manuals