User`s guide

Operations Instruction Osprey 75/102/130
AP-75720, Rev. 2.0 10
¾ Do not tilt the printer, stand it against a wall, or turn it upside down. Doing so may cause ink to leak inside
the printer. Also, movement after transport is not covered by the warranty.
¾
Have two or more people unpack and transport the printer.
¾
When lifting the printer out of the packing box, be sure to remove the vinyl cover first, then grab the holding
sides of the printer. Lifting the printer with the vinyl cover on may cause your hands to slip and drop or
damage the printer.
¾
Ensure that the plug has been disconnected from the power socket when it is not to be used for a long
time.
¾ Earth wires must be connected to wires or terminals that fulfil the conditions below.
• Earth terminals of power socket
• Earth wires with copper morsel that is at least 650 mm under ground
¾ When refilling ink or jet wash fluid, always wear the protective gloves supplied with the unit.
¾
The ink and jet wash fluid are poisonous. If skin contact occurs, wash with soap water and rinse well.
¾
Be sure to close the lid of the main tank tightly. If the lid is not tightly closed or loose, it will cause a defect
when purging, loading or unloading the ink.
¾ When performing the following work, always perform work with 2 people.
• Placement of the roll media
• Setting of the roll media
• Setting of the winding unit
¾ When perform the head cleaning:
• Put the gloves supplied with the printer on both hands.
• Only use the print head wiper supplied with the printer. Otherwise the nozzle may become clogged.
¾ Immediately after printing, the media guide and the platen is very hot. Perform work after the media guide
and the platen has cooled off.
¾
When cleaning the waste fluid tray, always wear the protective gloves supplied with the unit.
¾
When cleaning the print head surface, always wear the protective gloves supplied with the unit.
¾
When performing cleaning for long-term storage, always wear the protective gloves supplied with the unit.
¾
Be sure to switch the printer OFF and unplug the power cord before cleaning.
¾
Keep the printer horizontal during transportation.
¾ Before installation of options, always perform the following.
• Switch the power source to the product OFF.
• Remove the power source plug from the outlet.
• Remove all cables connected to the printer.
Failure to do so could result in damage to the printer or your computer.
• Touch a metallic section of the product, to remove any static electricity in your body. The electronic
components can be damaged from static electricity.
¾ When installing options, do not touch the elements on the circuit board. The elements on the boards can be
very hot, and can cause burns.
¾ When moving the print head cap into the accessory box after removed from the printer, discharge the
waste fluid from the print head cap enough. Otherwise the waste fluid may spilled out.
Downloaded From ManualsPrinter.com Manuals