Specifications

Falcon II Outdoor series printers – Maintenance Manual

AP-74065, Rev. 1.0, 21/11/03

Step 4 : Remove the screw fixing the T fence stationary plate.

1 = T fence stationary plate 2 = T fence

3 = Screw (M3x6) fixing the T fence stationary plate

Step 5 : Remove the T fence from the hook.

Step 6 : Pull out the T fence in the direction of the arrow as shown in the previous figure while being careful not to

damage the CR_ENC assembly.

Step 7 : Reinstall all parts in the opposite order of the removal procedure.

Notes :

¾ When installing the T fence, pay attention to the following :

 When there is a film on the T fence, remove the film and install the T fence.

 Properly install the T fence to the hooks on the T fence stationary plate.

Refer to the figure in step 2.

 The T fence and the hooks on the stationary plate must have a loose fit.

 When securing the stationary plate with screws, it must be loosened

enough so the T fence can be moved.

 Insert the T fence into the hooks on the T fence push plate and the

CR_ENC assembly. Refer to the following figure.

 Fix the T fence spring hook so that distance A of following diagram is about

1mm.