Specifications

Falcon II Outdoor series printers – Maintenance Manual

AP-74065, Rev. 1.0, 21/11/03

Notes :

¾ When installing the CR motor cable assembly connector, install the white cable on

the right side as shown in the previous figure.

4.6.2. Replacing the steel belt

Caution :

When replacing the steel belt, be careful not to cut your hands by the belt.

Notes :

¾ Do not damage the steel belt.

¾ Remove following covers before replacing the steel belt.

 Side cover R: refer to "Removing side cover R"

 Side cover L: refer to "Removing side cover L"

 Front cover: refer to "Removing the front cover"

 Carriage cover: refer to "Removing the carriage cover"

 Y rail cover: refer to "Removing the Y rail cover"

Step 1 : Unlock the head.

Notes :

¾ Refer to ‘Head Lock Menu’

Step 2 : Move the carriage from the capping position to the left.

Step 3 : Rotate the 2 steel belt adjustment screws counterclockwisely to loosen the steel belt.