Specifications

Falcon II Outdoor series printers – Maintenance Manual

AP-74065, Rev. 1.0, 21/11/03

1 = P_REAR_R sensor assembly 2 = Screws (M2x5) fixing the P_REAR_R sensor assembly

Step 5 : Replace the P_REAR_R sensor assembly.

Step 6 : Use the same procedure to replace the P_REAR_L sensor assembly.

Step 7 : Reinstall all parts in the opposite order of the removal procedure.

4.5.6. Replacing the suction fan assembly

Notes :

¾ Remove following covers before replacing the suction fan assembly.

 Side cover R: refer to "Removing side cover R"

 Side cover L: refer to "Removing side cover L"

 Front cover: refer to "Removing the front cover"

 Carriage cover: refer to "Removing the carriage cover"

 Y rail cover: refer to "Removing the Y rail cover"

 Media guide F: refer to "Removing media guide F"

Step 1 : Remove the suction fan assembly connector from the suction fan cable assembly.

Step 2 : If replacing the suction fan cable assembly, first remove the connector from the Mainboard assembly.

Step 3 : Remove the 2 screws fixing the suction fan assembly.

1 = Suction fan assembly 2 = Screws (M3x12) fixing the suction fan assembly

Step 4 : Replace the suction fan assembly.

Step 5 : Reinstall all parts in the opposite order of the removal procedure.