Specifications

Falcon II Outdoor series printers – Maintenance Manual

AP-74065, Rev. 1.0, 21/11/03

Step 14 : Reinstall all parts in the opposite order of the removal procedure.

Notes :

¾ During reinstallation of the plate, make sure there are no cables stuck.

4.3.2.4. Replacing the heater (Heater A) on a Falcon II Outdoor 4H printer

Before replacing the post fixer, make sure to have following items:

¾ 50” model : Heater A 50 (EY-80345)

¾ 64” model : Heater A 64 (EY-80340)

¾ 87” model : Heater A 87 (EY-80355)

¾ 2 x press plate (ME-24134)

¾ Silicone glue (AG-91240)

To replace the heater on a Falcon II Outdoor 4H printer, please follow the instructions mentioned below.

Step 5 : Remove side cover L.

Step 6 : Remove side cover R.

Step 7 : Remove the front cover.

Step 8 : Remove the Y rail cover.

Step 9 : Remove the rear paper guide.

Step 10 : Remove the heater strip.

Step 11 : Degrease the plate.

Notes :

¾ Make sure the plate is cleaned properly. Dust, glue and other parts must be

removed.

Step 12 : Stick the heater strip onto the plate.

Notes :

¾ Please make sure that there are no air bubbles under the heater strip. Air bubbles

below the heater strip could cause overheating of the heater strip.