Specifications

Falcon II Outdoor series printers – Maintenance Manual

AP-74065, Rev. 1.0, 21/11/03

Step 8 : Remove the screws of the plot platform.

1 = screws plot platform

Step 9 : Pull upwards the plot platform calibre and so remove the plot platform with fixer.

Step 10 : Remove the fixer.

Step 11 : Degrease the plot platform.

Notes :

¾ Make sure the plate is cleaned properly. Dust, glue and other parts must be

removed.

Step 12 : Stick the two fixer strips onto the plot platform.

Notes :

¾ Please make sure that there are no air bubbles under the heater strip. Air bubbles

below the heater strip could cause overheating of the heater strip.

Step 13 : Stick the isolation tape onto the heater strips.