Specifications

Falcon II Outdoor series printers – Maintenance Manual
60
AP-74065, Rev. 1.0, 21/11/03
Notes :
¾ During reinstallation of the plate, make sure there are no cables stuck.
4.3.2.2. Replacing the post fixer (Heater C) on a Falcon II Outdoor 4H printer
Before replacing the heater, make sure to have following items:
¾ 50” model : Post Fixer C 50 (EY-80343)
¾ 64” model : Post Fixer C 64 (EY-80333)
¾ 87” model : Post Fixer C 87 (EY-80353)
¾ 1 x sensor insul. Patch (ME-80310)
To replace the post fixer on a Falcon II Outdoor 4H printer, please follow the instructions mentioned below.
Step 1 : Remove side cover L.
Step 2 : Remove side cover R.
Step 3 : Remove the front cover.
Step 4 : Remove the Y rail cover.
Step 5 : Remove the front paper guide.
Step 6 : Remove the post fixer strip.
Step 7 : Degrease the plate.
Notes :
¾ Make sure the plate is cleaned properly. Dust, glue and other parts must be
removed.
Step 8 : Stick the post fixer strip onto the plate.
Notes :
¾ Make sure that the strips connect properly.
¾ Stick it as close as possible to the assembly holes. Make sure it does not touch the
assembly holes.
Notes :
¾ Please make sure that there are no air bubbles under the heater strip. Air bubbles
below the heater strip could cause overheating of the heater strip.