Specifications

Falcon II Outdoor series printers – Maintenance Manual

AP-74065, Rev. 1.0, 21/11/03

Step 5 : Remove the front paper guide.

Step 6 : Remove the dryer strip(s).

Step 7 : Degrease the plate.

Notes :

¾ Make sure the plate is cleaned properly. Dust, glue and other parts must be

removed.

Step 8 : Stick the dryer strip(s) onto the plate.

Notes :

¾ Make sure that the strips connect properly.

¾ Please make sure that the sensor (blue blocks) are positioned on the flat surface of

the front paper guide.

¾ Stick it as close as possible to the assembly holes. Make sure it does not touch the

assembly holes.

Notes :

¾ Please make sure that there are no air bubbles under the heater strip. Air bubbles

below the heater strip could cause overheating of the heater strip.

Step 9 : Stick onto the sensors a sensor insul. patch.

1 = sensor insul. patch 2 = assembly hole

Step 10 : Reinstall all parts in the opposite order of the removal procedure.