Specifications

Falcon II Outdoor series printers – Maintenance Manual

AP-74065, Rev. 1.0, 21/11/03

Step 4 : Remove the carriage cover.

Step 5 : Remove the Y rail cover.

Step 6 : Remove the front paper guide.

Step 7 : Remove the front heater strip(s).

Step 8 : Degrease the plate.

Notes :

¾ Make sure the plate is cleaned properly. Dust, glue and other parts must be

removed.

Step 9 : Stick the front heater strip(s) onto the plate.

Notes :

¾ Make sure that the strips connect properly.

¾ Please make sure that the sensor (blue blocks) are positioned on the flat surface of

the front paper guide.

Notes :

¾ Please make sure that there are no air bubbles under the heater strip. Air bubbles

below the heater strip could cause overheating of the heater strip.

Step 10 : Stick onto the sensor an isolation strip.