Specifications

Falcon II Outdoor series printers – Maintenance Manual
55
AP-74065, Rev. 1.0, 21/11/03
4.3. REPLACEMENT OF THE HEATER ELEMENT
To replace a heater element of the Falcon II Outdoor series printer, please follow the instructions mentioned in the
explanation of the appropriate heater element.
1. Falcon II Outdoor :
o 1. Replacing the front heater (Heater D) on a Falcon II Outdoor printer
o 2. Replacing the rear heater (Heater A) on a Falcon II Outdoor printer
2. Falcon II Outdoor 4H :
o 1. Replacing the dryer (Heater D) on a Falcon II Outdoor 4H printer
o 2. Replacing the post-fixer (Heater C) on a Falcon II Outdoor 4H printer
o 3. Replacing the fixer (Heater B) on a Falcon II Outdoor 4H printer
o 4. Replacing the heater (Heater A) on a Falcon II Outdoor 4H printer
Caution :
¾ In case the fuse of the heating element is locked, do not replace the fuse but replace
the appropriate heater element. Installation of a fuse of the heater element needs to
be done in a special production environment.
Important :
Before replacing parts, be sure to perform the following operations.
¾ Turn the machine power OFF.
¾ Remove the product's electrical plug from the socket. Otherwise, you may
suffer electric shock or the machine’s electric circuits may be damaged.
¾ Disconnect all cables from the machine. Not doing so could cause damage to
the printer.
4.3.1. Falcon II Outdoor 2 heaters : Heater elements
4.3.1.1. Replacing the front heater (Heater D) on a Falcon II Outdoor printer
Before replacing the front heater, make sure to have following items:
¾ 50” model : Heat Strip Assy Front 1 50 (EY-80236) and Heat Strip Assy Front 2 50 (EY-80237)
¾ 64” model : Heat Strip Assy Front 1 64 (EY-80216) and Heat Strip Assy Front 2 64 (EY-80217)
¾ 87” model : Heat Strip Assy Front 1 87 (EY-80226) and Heat Strip Assy Front 2 87 (EY-80227)
¾ 4 x sensor insul. Patch (ME-80310)
To replace the front heater on a Falcon II Outdoor printer, please follow the instructions mentioned below.
Step 1 : Remove side cover L.
Step 2 : Remove side cover R.
Step 3 : Remove the front cover.