Specifications

Falcon II Outdoor series printers – Maintenance Manual
328
AP-74065, Rev. 1.0, 21/11/03
(3) Check the CR
cables for skewed
insertion.
• Check the
connections of the
following
connectors.
• CR board : J235
• CR board : J201-
J216
• Mainboard : J137
– J152
→ Replacing the CR
board assembly
(4) The CR board
may have a
problem.
• Replace the CR
board.
→ Replacing the CR
board assembly
(5) The Mainboard
may have a
problem.
• Replace the
Mainboard .
→ Replacing the
Mainboard
assembly,
HDD_Extension
board assembly,
HEAD_DRV board
assembly and
cooling fan
assembly
3 The cutting operation is in
process, but the paper has not
been cut.
(1) Check the cutter
blade for shipping
and deterioration.
• Replace the cutter.
→ User’s Guide
4 The paper has not been cut as
smoothly as expected, resulting
in jamming.
(2) Check if the
cutter cap is
securely installed.
• Reset the cutter
cap securely.
→ User’s Guide
(3) Check if the
cutter moves up and
down smoothly.
• Reinstall the cutter
spring.
-
(4) Check the cutter
grooves for
accumulated paper
dust and slips.
• Remove the
accumulated paper
dust along the
direction of the
grooves.
→ User’s Guide
(5) Check if the
cutter blade is
parallel with the
groove.
• Make adjustments.
→ Replacing the
cutter holder, cutter
spring, cutter cap,
solenoid assembly
and solenoid spring.
(1) The sub-platen
(cutter groove)
requires daily
maintenance.
• Clean the surface
of the sub-platen
5 The cutting operation is in
process but the paper does not
fall off.
(2) The sub-platen,
paper guide or the
paper may be
charged with static
electricity.
• Provide a proper
ground.
• Check and adjust
the ambient
humidity so that it
meets the normal
operation conditions
of the product and
paper.
-
6 Inaccurate paper cutting (1) Check the cutter
blade for chipping
and deterioration.
• Replace the cutter.
→ User’s Guide