Specifications

Falcon II Outdoor series printers – Maintenance Manual
327
AP-74065, Rev. 1.0, 21/11/03
a) The solenoid
moves up and
down:
check the cutter’s
down position
relative to the cutter
groove.
OK :
The cutter’s service
life has exceeded or
the cutter is
damaged. Replace
the cutter.
NG :
Adjust the position
of the cutter holder.
→ User’s Guide
→ Cutter adjustment
b) It does not move
up or down.
• The connectors
may have poor
contacts.
Check the
connections of the
following
connectors.
• CR board : J235
• CR board : J201-
J216
• Mainboard : J137-
J152
→ Replacing the CR
board assembly
→ Replacing the
Mainboard
assembly,
HDD_Extension
board assembly,
HEAD_DRV board
assembly and
cooling fan
assembly
(8) Open CR cable,
faulty solenoid
assembly, faulty
board assembly,
etc. may be the
causes.
• Replace the CR
tape power cables.
• Replace the
solenoid assembly
• Replace the CR
board assembly
• Replace the
Mainboard
assembly
→ Replacing the
steel bearer, tube
guide, CR tape
power cable and ink
tube.
→ Replacing the
cutter holder, cutter
spring, cutter cap,
solenoid assembly
and solenoid spring.
→ Replacing the CR
board assembly
→ Replacing the
Mainboard
assembly,
HDD_Extension
board assembly,
HEAD_DRV board
assembly and
cooling fan
assembly
(1) Check if the
paper (output) size
on the application
side is correct.
• Correct the paper
(output) size on the
application side.
- 2 Cutting has been performed
during printing.
(2) The program
ROM may have
failed.
• Upgrade the
firmware version.
→ Firmware
installation