Specifications

Falcon II Outdoor series printers – Maintenance Manual
318
AP-74065, Rev. 1.0, 21/11/03
(5) Check the T
fence for
contamination.
• Clean the T fence
• If contaminants
cannot be cleaned
up by cleaning,
replace the T fence.
→ Replacing the T
fence
(6) Make sure that
the CR_ENC
assembly and the T
fence are not
interfering.
• If they interfere
with each other,
adjust the
installation positions
of the CR_ENC
assembly and the T
fence.
• If the adjustments
do not improve this,
replace the
CR_ENC assembly
and the T fence.
→ Replacing the T
fence.
→ Replacing the
CR_ENC assembly
(7) Check if the
pump is running
during the cleaning
operation.
• Check that
connections of
Mainboard
connectors J160-
J161 are good.
• Replace the pump
motor assembly.
• Replace the
Mainboard
assembly.
→ Replacing the
Mainboard
assembly,
HDD_Extension
board assembly,
HEAD_DRV board
assembly and
cooling fan
assembly
→ Replacing the
pump motor
assembly.
(8) Check if the
nozzle face is wiped
correctly.
• Using the wiper,
wipe the nozzle face
well.
→ User’s Guide
(9) Check the
cleaning wipers for
contamination.
• Using the provided
cleaning cloth for
cleaning the wipers,
slightly dampen it
with cleaning liquid
and wipe the
surfaces of the
cleaning wipers,
then recheck their
conditions by
performing the
cleaning operation.
• If the ink is solid
and does not come
off by wiping,
replace the wiper.
→ User’s Guide.
→ Replacing the
cleaner
(10) Check if the QR
code is input
correctly.
• Input the correct
QR codes.
→ Head rank input
menu
(11) The head
assembly may be
damaged.
• Replace the
damaged head
assembly
→ Replacing the
print head assembly
and head tape
power cable.