Specifications

Falcon II Outdoor series printers – Maintenance Manual
254
AP-74065, Rev. 1.0, 21/11/03
7.14. CUTTER ADJUSTMENT
This section explains the procedure for adjusting the cutter.
When replacing the sub-platen, replacing the solenoid assembly, or removing/installing media guide F, use this procedure
to adjust the cutter.
Step 1 : Confirm if the media has been cut correctly.
Notes :
¾ Refer to “Cutter Endurance menu".
Step 2 : If media guide F has been installed at an angle, adjust it.
Notes :
¾ Refer to “Removing media guide F".
Step 3 : Loosen the screw fixing the cutter holder.
1 = Cutter holder 2 = Screws (M3x6) fixing the cutter holder
Step 4 : Slide the cutter holder forward and backward as shown in the following figure so that the dimension between the
cutter blade and the cutter groove of the sub-platen is 0.2 to 0.7 mm.