Specifications

Falcon II Outdoor series printers – Maintenance Manual
242
AP-74065, Rev. 1.0, 21/11/03
Step 5 : Using the colour printed by the reference head as a guide, move the head forward/aft adjustment screw,
adjusting the head forward/back position until each of the colour is straight.
a. Enlarge with magnifying glass. Adjust so that two colours converge on a perpendicular line. (See A in
following figure.)
b. Confirm that row B adjustments have been made. (See B in following figure.)
c. Confirm that solids are properly printed. (See C in following figure.)
1 = Media feed direction 2 = Reference head
3 = Fore/Aft Adjustment Screws
Notes :
¾ For 87-inch specifications, the heads 5-A, 5-B, 6-A, 6-B, 7-A, 7-B, 8-A, 8-B are
added.
¾ In the event that top/bottom margins do not match due to some property of head,
adjust amount of top/bottom offset.
Step 6 : Print a check pattern so that section A of following diagram is a straight line.