Specifications

Falcon II Outdoor series printers – Maintenance Manual
240
AP-74065, Rev. 1.0, 21/11/03
Step 5 : Magnifying by the loupe, move the angle adjustment screw on the head to adjust the head angle until dotted line
on printing A becomes straight.
Step 6 : If CW is aligned but CCW is not, make adjustments until amount of CW and CCW offset are identical.
1 = Angle adjustment screw
Notes :
¾ For 87-inch specifications, the head 5-A, 5-B, 6-A, 6-B, 7-A, 7-B, 8-A, 8-B are
added.
Step 7 : Tighten the screw fixing the head stationary plate.
7.7.2. Front and back of head adjustment
Step 1 : Start the self-diagnostic function.
Notes :
¾ Refer to “Self-Diagnosis Function".