Specifications

Falcon II Outdoor series printers – Maintenance Manual
234
AP-74065, Rev. 1.0, 21/11/03
Step 4 : Send new firmware data by MS-DOS copy command etc. (e.g. "COPY /B rh2.04.jfl LPT1")
Firmware installation will take about 60 seconds. The following messages will appear in order on the LED
display on the operation panel during installation.
¾ “Loading"
¾ "Erasing"
¾ "Copying"
¾ "Comparing"
¾ "End"
Step 5 : Check if the buzzer sounded and whether the firmware was installed correctly.
Step 6 : Power the unit OFF.
Important :
After installation of the firmware onto the Falcon II Outdoor 4 heater, you must
upgrade the heater system board.
(3) Updating the heater system board (4 heater printers ONLY!).
To update the heater system board of a Falcon II Outdoor 4 heater printer, please follow the instructions mentioned below.
Important :
¾ Before updating the heater system board, make sure you already installed the
firmware into the Falcon II Outdoor 4 heater printer.
Step 1 : Make sure the printer is OFF.