Specifications

Falcon II Outdoor series printers – Maintenance Manual
194
AP-74065, Rev. 1.0, 21/11/03
(5) Mechanical parameter
Update the mechanical position parameters. The setup items are as follows.
¾ Top distance
¾ Bottom distance
¾ Side margin
¾ P_REAR sensor position
* Mechparm *
Top Length 0 – 40.0 +
5.0 mm -
* Mechparm *
Bottom 0 – 40.0 +
5.0 mm -
* Mechparm *
Side 0 – 20.0 +
5.0 mm -
* Mechparm *
Rear Sensor 0 – 27.0 +
17.0 mm -
↓ ENTER
* Mechparm *
Update Parameter
↓ ENTER
* Mechparm *
Updating Parameter
(6) Ink parameter
This updates the ink parameter. The setup items are as follows.
Set: Ink not filled
Reset: Ink filled
Notes :
¾ When "set" has been selected on the ink parameter update menu, the product
implements initial filling operations at the next start up.