Specifications

Falcon II Outdoor series printers – Maintenance Manual
171
AP-74065, Rev. 1.0, 21/11/03
5.5.4.2. Front and back
To perform a Head Front/Back Adjustment, please follow the steps mentioned below.
Step 1 : Go to [Adjust : Head Slant].
Step 2 : Print out [Front/Back] pattern
Step 3 : Loosen the screw, which secures the Head Fixing Plate.
1 = Head fixing plate securing screw
2 = Front/Back Adjustment Screw
Step 4 : Adjust the head front/back position by moving the Head Front/Back Adjustment Screw.
Caution :
Please note that the reference Head of the 50 and 64 inch model is the first Head, the
reference Head of a 87 inch model printer is the third Head.
Due to the head characteristics, the top (back) and bottom (front) lines of the pattern
might not be aligned. If this is the case, adjust the bottom (front) and top (back)
difference amount equally.