Specifications

Falcon II Outdoor series printers – Maintenance Manual
119
AP-74065, Rev. 1.0, 21/11/03
Step 3 : Remove the E ring fixing the cursor roller assembly (KY-80040) of downside.
1 = CR cursor assembly (KY-80040) 2 = E ring fixing the cursor roller assembly.
Step 4 : Replace the cursor roller assembly (KY-80040).
Step 5 : Install the spacers and the other parts as shown in the following figure.
1 = E ring fixing the side cursor roller assembly 2 = High-load bearing of the side cursor roller
assembly
3 = Brass spacer of the side cursor roller assembly 4 = E ring of the cursor roller assembly
5 = High-load bearing of the cursor roller assembly of
downside
6 = Brass spacer of the cursor roller assembly
Step 6 : Apply the screw lock to the cursor axis, and install the cursor roller assembly with the axis at the lower position.
Notes :
¾ Be sure that the screw lock does not contaminate the cursor roller or the spacer.