Specifications

Falcon II Outdoor series printers – Maintenance Manual
111
AP-74065, Rev. 1.0, 21/11/03
Step 6 : Remove the damper assembly from the print head assembly.
1 = Head tape power cable 2 = Damper assembly
3 = Print head assembly 4 = H ink tube, O-ring
Step 7 : Remove the H ink tube, coupling screw and O-ring from the damper assembly.
Step 8 : Replace the damper assembly.
Step 9 : Replace the H ink tube and O-ring.
Notes :
¾ Please soak the O-ring in cleaning liquid before installation.
Step 10 : Reinstall all parts in the opposite order of the removal procedure.
Notes :
¾ When tightening coupling screws, finger-tighten those. If using tools, it may result
in cracking where the screws fix damper and fail to fill the ink.
¾ Do not grasp the film area of the damper strongly. Doing so may cause faulty
damper and fail to print.