System information
Command Keyboard Shortcut
Set track heights to default height Ctrl+`
Minimize/restore the window docking area F11 or
Alt+`
Maximize/restore the timeline vertically and horizontally
(window docking area and track list will be hidden)
Ctrl+F11 or
Ctrl+Alt+`
Minimize/restore the track list Shift+F11 or
Shift+Alt+`
Zoom in/out horizontally in small increments (if timeline has focus) Up/Down Arrow
Zoom in/out horizontally in large increments or zoom to selection (if
one exists)
Ctrl+Up/Down Arrow
Zoom in time until each video thumbnail represents one frame Alt + Up Arrow
Zoom waveforms in/out vertically (audio only) Shift+Up/Down Arrow
Cursor placement, loop region, and time selection
Most of the cursor placement commands, when combined with the Shift key, also perform selection.
Command Keyboard Shortcut
Center view around cursor \
Go to Ctrl+G
Set end of time selection Ctrl+Shift+G
Go to beginning of time selection or viewable area (if no time
selection)
Home
Go to end of time selection or viewable area (if no time selection) End
Go to beginning of project Ctrl+Home or
W
Go to end of project Ctrl+End
Select loop region Shift+Q
Restore previous five time selections Backspace
Move left by grid marks Page Up
Move right by grid marks Page Down
Move left/right one pixel (when Quantize to Frames is turned off) Left or Right Arrow
Move to previous/next marker Ctrl+Left/Right Arrow
Move one frame left/right Alt+Left or Right Arrow
Move left/right to event edit points (including fade edges) Ctrl+Alt+Left/Right
Arrow
Jog left/right (when not in edge-trimming mode or during playback) F3/F9
Move edit cursor to playback cursor position during playback Alt+Down Arrow
618CHAPTER 33