System information
Button Description
displayed with a *. Press the next V-Pot (to the right) to add the effect.
Settings Press to adjust track or bus settings using the F1 through F6 buttons.
n F1: Hold the button and turn the V-Pot to change the
automation recording mode for each track and bus track. For
more information, see "Recording Track Envelope and
Keyframe Automation" on page 270.
n F2: Hold the button and turn the V-Pot to change the current
panning mode. For more information, see "Audio panning
modes" on page 444.
n F3: Hold the button and press the V-Pot to change the track
phase.
n F4: Hold the button and turn the V-Pot to change record input
monitoring settings when you're using an ASIO audio device.
For more information, see "Recording audio" on page 116.
n "Recording audio" on page 116.
When the Sends button is selected, press the Settings button
and hold F5 while pressing the V-Pot to change a track's bus
or assignable effects send level to Pre Volume or Post
Volume. Press the Sends button to scroll through the
available bus and effects sends.
n F6: Press the Settings button and hold F6 while pressing the
V-Pot on a channel to return the channel's settings to the
track defaults. For more information, see "Setting Default
Track Properties" on page 252.
Fader Banks buttons
The Fader Banks buttons control the behavior of the channel section controls.
Button Description
Bank Press the left or right arrow button to scroll the channels 8 units at a
time.
For example, if tracks 1-8 are currently displayed, pressing the right
arrow will change to tracks 9-16.
USING HARDWARE CONTROLLERS537