User manual

8
Installation
Accessories
Optical cables in different lenghts from 0.5 m to 20 m for S/P-DIF and ADAT
TM
transfers.
MW-02/19, Mounting plate to install two MC products side by side into one unit of a 19” rack.
MW-03/19, Set of two rack mounting angles to install one MC product on the rear side of a 19” rack.
MW-05/19, Set of two rack mounting angles to install one MC product frontally into one unit of a 19” rack.
For all peripheral products please have a look on our website: www.mutec-net.com
Product Registration for Warranty and Support
We ask you to be so kind to register your MUTEC product through our website immediately after buying. This ensures full
warranty services over a period of two years after purchasing the product. More-over, for all registered products we offer to our
customers technical support. We also will inform you about product updates and new products which may of interest for you
(on voluntary base, of course).
Please regsiter your product at:
www.mutec-net.com > Service > Product Registration
Or for direct access type in the following URL into your browser:
http://www.mutec-net.com/produktregistrierung.php?lng=en
Social Media
Content of the Box
Your MC-3+ Smart Clock USB was packed carefully. Nevertheless we recommend to check the content directly after opening
the package:
1 x MC-3+ Smart Clock USB
1 x USB cable
1 x RCA-BNC adapter
1 x Power cable
1 x Manual
If there are any damages visible, please refer to Safety Instructions and Warranty Regulations for further details.
Placing the Device
The unit should be set up as closely as possible to the devices to which it will be connected with to avoid excessive cable
lengths. The four custom-designed case feets include a rubber ring to protect the ground’s surface from being damaged.
The device can be mounted into a standard 19“ rack and will require one unit. Therefore, we offer an optional rack mounting
kit, called MW-05/19. This includes two rack angles which need to be screwed at each side of the device‘s case. Before moun-
ting the device into a 19“ rack, please unscrew the four rubber feets with a suitable screwer. Install the device so that one unit
of rack space is left free both above and below the device to allow for sufficient ventilation! Additional slide-in rails on the
rack inside are recommended for safe installation. This will also avoid long-term mechanical deformation of the housing.
facebook.com/mutecpro pinterest.com/mutecpro
https://plus.google.com/116705378800155548696