MT2001USBi MD/LD TA AF P PT Y DI S BD/ ENT 1 2 3 5 12 9 15 16 25 Operating and Installation Guide MD/LD TA AF P PT Y DI S BD/ ENT 6 8 10 7 13 11 19 20 21 22 23 4 (1-6) 24 14 26
P PT Y DI S BD/ ENT LOCATIONS OF CONTROLS 1 2 3 5 12 9 15 16 25 MD/LD TA AF P PT Y DI S BD/ ENT 6 8 10 7 13 11 19 20 21 22 23 AF MD/LD 24 14 26 TA 4 (1-6) P PT Y DI S BD/ ENT 1. POWER ON/OFF ( ) 2. FUNCTION SELECT BUTTON: CONTROLS FOR BASS/TREBLE/BALANCE/FADER / INITIAL VOLUME / CT / TA VOL / EON / DSP 3. VOL UP/VOL DOWN BUTTON: CONTROLS FOR BASS/TREBLE/BALANCE/FADER / 1 /DSP 2 3 5 9 15 12 INITIAL VOLUME / CT / TA VOL / EON 4. PRESET STATIONS (1,2,3,4,5,6) 5.
INSTALLATION PRECAUTIONS • Choose the mounting location carefully so that the unit will not interfere with the normal driving functions of the driver. • Avoid installing the unit where it would be subject to high temperatures, such as from direct sunlight or hot air from the heater, or where it would be subject to dust, dirt or excessive vibration. • Use only the supplied mounting hardware for a safe and secure installation. • Be sure to remove the front panel before installing the unit.
1. UNIT 2. RELEASE CASE 3. DASH BOARD 4. HEX NUT 5. LOCK WASHER 6. PLAIN WASHER 7. CAR BODY 8. REAR SUPPORT STRAP 9. TAPPING SCREW 10. M5 X 15 HEX BOLT TO SUPPORT THE UNIT 4 3 Dashboard 4 6 5 8 2 10 7 5 1 9 4 6 ISO CONNECTOR RCA Jack Line Out: Red (right) White (left) B RCA Jack Line In: Red (right) White (left) 1 3 5 7 2 4 6 8 CONNECTOR A 1. 2. 5 7 3. 4. MEMORY +12V 4 8 A 5. AUTO ANTENNA OUTPUT 6. 7. +12V (TO IGNITION KEY) 8. GROUND Note: (connector A no.
OPERATING INSTRUCTIONS 1. POWER ON/OFF ( ) By pressing this key, the unit is on or off. This unit is turned on by pressing any key. 2. FUNCTION SELECT BUTTON: BASS/TREBLE/BALANCE/FADER / INITIAL VOLUME / CT / TA VOL / EON / DSP) 3. VOLUME UP/DOWN Turning VOL knob (right/left) to adjust VOL/BAS/TRE/BAL/FAD. To select other functions, press the VOL knob shortly until the desired functions are shown on the display. Figure 1 shows how to control functions that are selected using the VOL knob.
5. ‘AF/REG’ function (ALTERNATIVE FREQUENCIES) When pressed momentarily, AF/REG switching mode is selected. When AF/REG switching mode is selected, the radio checks the signal strength of the AF all the time. When pressed long, it is activated as regional mode ON/OFF. – Regional mode ON: AF switching or PI SEEK is implemented to the station which have all PI codes same as current station. REG segment is turned on, in LCD display.
10. BAND BUTTON (BD) Each band is toggled cyclically by pressing this key FM1---FM2---FM3--MW1--MW2. 11. AUTOMATIC OR MANUAL TUNING (FREQ UP OR FREQ DOWN ) (A) RADIO MODE When pressed momentarily, these keys are operated as SEEK tuning mode. When pressed longer than 1 sec., they are operated as MANUAL tuning mode. (B) CD/MP3 PLAYER MODE When pressed momentarily, they are operated as TRACK UP or TRACK DOWN mode. When pressed longer than 1 sec., they are operated as CUE or REVIEW mode. 12.
20. REPEAT BUTTON When this button is pressed, “RPT ON” indication is displayed and play of the selected track will be continually repeated until the Track repeat mode is cancelled by pressing ‘RPT’ button again. 21. INTRO BUTTON (Preview all Tracks) When this button is pressed, “INT ON” indication is displayed and the first several seconds of each track of the disc is played. Press again to stop intro and listen to track. 22.
Connecting iPOD You can connect your iPOD portable device and play songs from the car stereo. Only the audio feature is supported, other features of iPOD is not supported. An additional cable is required, Part number PC7-HU, Available from Motor World Branches and most Mutant stockists. Playing Songs in iPOD You now can play songs in iPOD once the cable is properly connected. 1. Press MD repeatedly until I-POD shows in the display. 2. Press A/PS. 3.
TECHNICAL SPECIFICATIONS CD/MP3 PLAYER SECTION Signal to Noise Ratio Channel Separation Frequency Response > 60 dB > 50 dB (1kHz) 20Hz - 20 kHz TUNER (FM) Frequency range Intermediate frequency Sensitivity Stereo separation Signal to noise ratio Channel step 87.5-108 MHz 10.7 MHz 2.8 µV 30 dB 50 dB 50 kHz TUNER (MW) Frequency range Intermediate frequency Usable sensitivity 522-1620 KHz 450 KHz 32 dB LINE-OUT Output Impedance 5V (max.
