Operating instructions

122
Learning function
If an AV component is not a DENON product, or if it cannot be operated via codes provided in the AVC-A1XVA remote control's internal preset
memory, or if its codes cannot be successfully learned by the AVC-A1XVA remote control, then you should use the remote control that was
supplied with that AV component to operate the component.
1, 6
2
IR segment
3
1
Press and hold the RC SETUP button for at
least three seconds.
• The IR segment blinks twice.
2
Press the “9, 7, 5” button (9
→
7
→
5) to select Learning
setup.
• The IR segment blinks
twice, indicating the remote
is in Learning set up mode.
3
Press the mode selector button
for the component you want to
learned.
Learning is not possible for the
AMP, ZONE2, ZONE3 ZONE4
and SYSTEM CALL modes.
4
Press the button that you wish to be learned.
• The display will go off and the unit will enter the learning
standby mode.
If a button that cannot be “learned” is pressed, the IR
segment lights and the learning setup mode is cancelled.
The HOME button cannot be “learned”.
5
Point the remote control units directly at each other and press
and hold in the button on the other remote control unit which
you want to “learn”.
• The display turns on again and the IR segment blinks twice
to indicate that the code is successfully captured.
6
Press and hold the RC SETUP button for at
least three seconds to exit programming.
Other remote
control unit
Other buttons can be “learned” by repeating steps 4 and
5.
The mode can be switched by pressing a mode selector
button.
If the IR segment displays one long flash, a leaning error
has occurred. Try repeating this step again until a
successful capture occurs.
NOTES:
•To cancel the learning setup mode, press the RC SETUP button
for at least three seconds.
• Do not try to learn anything to the RC SETUP button.