User manual

4
2. Installation
A
nd
S
etup
NOTE: Before installation, please inspect the unit. Be sure that nothing inside the package is
damaged. Please keep the original package in a safe place for future use.
2-1. Rear Panel View
PowerMust
PowerMustPowerMust
PowerMust
864S NetGuard/
PowerMust
PowerMustPowerMust
PowerMust
1188S NetGuard/
PowerMust
PowerMustPowerMust
PowerMust 1512S NetGuard/ PowerMust
PowerMustPowerMust
PowerMust 2016S NetGuard
PowerMust
PowerMustPowerMust
PowerMust
2520S NetGuard/
PowerMust
PowerMustPowerMust
PowerMust 3024S NetGuard/
1. Programmable outlets: connect to non-critical loads.
2. Output receptacles: connect to mission-critical loads.
3. AC input
4. Input circuit breaker
5. Network/Fax/Modem surge protection
6. Emergency power off function connector (EPO)
7. USB communication port
8. RS-232 communication port
9. SNMP intelligent slot
10. External battery connector (only available for L model)
11. External battery pack numbers detection port
2-2. Install The UPS
For safety consideration, the UPS is shipped out from factory without connecting battery wires.
Before install the UPS, please follow below steps to re-connect battery wires first.
Step 1
Step 2
Step 3
Remove front panel.
Connect the AC input and
re-connect battery wires.
Put the front panel back to the
unit.
Rack-mount Installation
Step 1 Step 2