User manual

Step 6: Turn on the UPS

Press the ON/Mute button on the front panel for two seconds to power on the UPS.

Note: The battery charges fully during the first five hours of normal operation. Do not expect

full battery run capability during this initial charge period.

Step 7: Install software

For optimal computer system protection, install UPS monitoring software to fully configure UPS

shutdown. Please follow steps below to download and install monitoring software:

1. Go to the website http://www.power-software-download.com

2. Click ViewPower software icon and then choose your required OS to download the software.

3. Follow the on-screen instructions to install the software.

4. When your computer restarts, the monitoring software will appear as an orange plug icon

located in the system tray, near the clock.

2-4 Battery Replacement

NOTICE: This UPS is equipped with internal batteries and user can replace the batteries without

shutting down the UPS or connected loads.(hot-swappable battery design) Replacement is a

safe procedure, isolated from electrical hazards.

CAUTION!! Consider all warnings, cautions, and notes before replacing batteries.

Note: Upon battery disconnection, equipment is not protected from power outages.

Step 1 Step 2 Step 3

Remove front panel. Disconnect battery wires. Pull out the battery box by

removing two screws on the front

panel.

Step 4 Step 5 Step 7

Remove the top cover of

battery box and replace the

inside batteries.

After replacing the

batteries, put the battery

box back to original location

and screw it tightly.

Re-connect the battery wires.

Step 8

Put the front panel back to the unit.